问题描述
- redhat5.10安装10g rac问题
-
[root@alice1 ocfs]# /etc/init.d/o2cb configure
Configuring the O2CB driver.This will configure the on-boot properties of the O2CB driver.
The following questions will determine whether the driver is loaded on
boot. The current values will be shown in brackets ('[]'). Hitting
without typing an answer will keep that current value. Ctrl-C
will abort.Load O2CB driver on boot (y/n) [n]: y
Cluster stack backing O2CB [o2cb]:
Cluster to start on boot (Enter "none" to clear) [ocfs2]:
Specify heartbeat dead threshold (>=7) [31]: 61
Specify network idle timeout in ms (>=5000) [30000]:
Specify network keepalive delay in ms (>=1000) [2000]:
Specify network reconnect delay in ms (>=2000) [2000]:
Writing O2CB configuration: OK
Checking O2CB cluster configuration : Failed
解决方案
A B 端配置IP节点
[root@alice2 init.d]# vi /etc/hosts
Do not remove the following line, or various programs
that require network functionality will fail.
127.0.0.1 localhost.localdomain localhost
::1 localhost6.localdomain6 localhost6
#Public
192.168.56.5 alice1
192.168.56.6 alice2
#Private
10.10.10.5 rac1priv
10.10.10.6 rac2priv
#Virtual
192.168.56.100 rac1vip
192.168.56.101 rac2vip
ocfs与linux的内核版本一致，求高手 大神不吝解答，万分感谢