端口概述
Port 1-16 是内联刀片的downlink口
Port 17-18 是switch互 联用，默认是disable的
Port 19是给Blade On-board Administrator用
Port 20-24 是uplink口
连到交换机的Console口
To access the switch locally:
1. Connect the switch DB-9 serial connector, using the null-modem serial cable to a local client device (such as a laptop computer) with VT100 terminal emulation software.
2. Open a VT100 terminal emulation session with these settings: 9600 baud rate, eight data bits, no parity, one stop bit, and no flow control.
初次配置概述
1. 登录默认密码：user级别口令： user/user，管理员口令: admin/admin
2. 修改默认口令 cfg → sys → access → user → admpw → apply → save
>> Main# /cfg
>> Configuration# sys
>> System# access/user/admpw
Changing ADMINISTRATOR password; validation required:
Enter current admin password:
Enter new administrator password:
Re-enter new administrator password:
New administrator password accepted.
>> System# apply
>> System# save
千万记得每次更改完配置，必 须用apply才会生效，为保证重启后也继续生效，一定要save!
网络配置 ，21端口上联到Core 1，22端口上联到Core 2，所以要添加此端口关联到所有 VLAN，并且在上联端口上enable tag，所有downlink都不需要tag
配置21和22端口为tagged
配置命令 cfg → port 22→ ena → cur →tag e →apply → save → cur
配置21和22端口到网管vlan 11
（同样的配置重复操作，直到把21、22口加入到所有需要加入的vlan）
配置命令cfg → l2 → vlan 11 → ena →add 21 → add 22 → apply → save → cur
配置管理IP地址
配 置命令cfg → l3 → if 1 → addr → mask → ena → apply → save → cur
配置交换机gw
配置命令cfg → l3 → gw 1 → addr → ena → apply → save → cur